Australian Swing Lift V1.0

For transport of 40ft, 20ft and dual 20ft containers.
There are two sets of attachers one in the trailer for transport and one in the crane for loading and unloading.
To unload a container from the truck maneuver legs into lifting position then before moving crane arms disconnect the container/containers from the trailer. This will then allow the crane arms to attach once in the correct location.
To load a container to the truck maneuver legs into lifting position then move crane arms into correct location for attaching to container/containers, attach to the containers and lift onto the truck, detach container from lifting arms, pack up the lifting arms and legs into the transport position and then you will be able to attach containers to trailer.
When lifting Dual 20ft containers once you disconnect one using the Q key, cycle through your implements using the G key until the connected container is selected, then use Control Q to disconnect second container. This will prevent the 1st container re connecting.
Trailer has 3 separate colour options: Crane Arms, Chassis and Guards.
Simple IC is used to change and cover the rear signs on the trailer.
The Trailer is able to load and unload the Skel trailers.
Fold Key Slides the arms from 40ft to 20ft.

Key bindings:
Front loader arm controls are for legs (left click mouse)
Front loader tool is for crane base (left click mouse)
Tool Axis three is for lower crane arm (left & right click mouse)
Tool Axis Four is for the upper crane arm (left & right click mouse)
You will also need this copy of the containers, there is a bit of a knack to using this mod so some practice will be needed.
Special Thanks to Tork and Jeremy for their help with the attachers.

Credits:

AlexScom

Download mod

File	File size
FS22_Australian_SwingLift_Trailer	44 MB